This video tutorial from OzLabs will show you how power the one-watt high powered LED using 120 volt source using a 12 volt adapter.
Keep Your Connection Secure Without a Monthly Bill. Get a lifetime subscription to VPN Unlimited for all your devices with a one-time purchase from the new Gadget Hacks Shop, and watch Hulu or Netflix without regional restrictions, increase security when browsing on public networks, and more.
Other worthwhile deals to check out:
How To:
Make an Infrared Mask to Hide Your Face from Cameras
How To:
Make an AC Arc Welder Using Parts from an Old Microwave, Part 1
How To:
Recharge non-rechargeable batteries in seconds
How To:
Mod a Wii Hori fighting stick to work on the Xbox 360 using Sanwa parts
How To:
Fix Dead Lithium-Ion Batteries That Won't Hold a Charge Anymore
How To:
Hack your electricity meter
How To:
10 Unique & Practical Ways to Repurpose Your Old Hard Disk Drives
News:
Infrared LEDs Protect Your License Plate Number from Police Cams
How To:
Hack a coin operated laundry machine
How To:
Hack a satellite dish into a WiFi signal booster
How To:
Build a low cost portable hamstick antenna
How To:
Eavesdrop from a Distance with This DIY Parabolic "Spy" Microphone
How To:
Prep through hole component for solder installation
How To:
Quick-N-Dirty Circuit Board Repair: How to Patch Faded or Corroded Traces with Pencil Lead
How To:
Get your PSP hooked up to the Internet without needing wifi
How To:
Hack a Vending Machine in 3 Easy Steps
How To:
Extract an RFID chip from a card & make it wearable
How To:
Convert Your Old Apple iMac G4 into a Cable-Ready HDTV
How To:
Build a simple carboard magnet generator
How To:
Build a high-powered air cannon that shoots rolled up T-shirts
How To:
Make an Infrared Mask to Hide Your Face from Cameras
How To:
Make an AC Arc Welder Using Parts from an Old Microwave, Part 1
How To:
Mod a Wii Hori fighting stick to work on the Xbox 360 using Sanwa parts
How To:
Recharge non-rechargeable batteries in seconds
How To:
Fix Dead Lithium-Ion Batteries That Won't Hold a Charge Anymore
How To:
Hack your electricity meter
How To:
10 Unique & Practical Ways to Repurpose Your Old Hard Disk Drives
News:
Infrared LEDs Protect Your License Plate Number from Police Cams
How To:
Hack a coin operated laundry machine
How To:
Hack a satellite dish into a WiFi signal booster
How To:
Build a low cost portable hamstick antenna
How To:
Eavesdrop from a Distance with This DIY Parabolic "Spy" Microphone
How To:
Prep through hole component for solder installation
How To:
Quick-N-Dirty Circuit Board Repair: How to Patch Faded or Corroded Traces with Pencil Lead
How To:
Get your PSP hooked up to the Internet without needing wifi
How To:
Hack a Vending Machine in 3 Easy Steps
How To:
Extract an RFID chip from a card & make it wearable
How To:
Convert Your Old Apple iMac G4 into a Cable-Ready HDTV
How To:
Build a high-powered air cannon that shoots rolled up T-shirts
How To:
Build a simple carboard magnet generator
1 Comment
I appreciate that most people will have to make do with the tools available, but when a company demonstration video shows wire being hacked by a knife and cutters......where's the wire strippers?
There are other bad assembly techniques too, should really be showing users how to do it properly.
Share Your Thoughts